![]() If you determine it’s a single bad slot, then it’s time to RMA the motherboard. ![]() Some motherboards show a preference for one set of slots or the other. If they were in slots one/three, then try them in two/four. Pull the modules and blow out the slots with compressed air. If you have another set of DRAM available, try those. If both boot up the rig, then move to he next suggestion. Check each DIMM individually to ensure it can boot the system by itself. Q-Tips or cotton swabs can leave fibers on the contacts. I suggest using foam swabs and isopropyl alcohol (rubbing alcohol). This can have a number of causes: You may have a bad DIMM. For example, it may show only one DIMM even if two are installed, or it may be showing both but only half the amount of DRAM that it should. Ensure that it’s showing the full amount of DRAM installed. It’s possible the system isn’t seeing your entire amount of DRAM.You can manually set the DRAM to unganged (basically, single-channel mode) or ganged (dual-channel mode) regardless of which slots the modules are in. If it’s an AMD motherboard, there is often a setting in the BIOS for ganged or unganged mode.If you’re using an odd number of memory modules on a dual-channel motherboard, you can use flex mode, which allows different sizes of DIMMs to work together. Most dual-channel motherboards color-code the slots for you to fill for dual-channel operation. Generally, a four-slot motherboard should use (from the CPU) slots one and three or slots two and four for a two-DIMM setup, or slots one through four for a four-DIMM setup. Your manual should show the correct slots for the DRAM. The memory modules may not be in the proper slots.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |